- Oct 11, 2014
- 180
- 44
Today I received a letter from the Police Department claiming I was involved in a hit and run. They list the date and approximate time. With my Video Surveillance recordings, I can prove I arrived home before that time and did not leave until the next morning (if I export clips from all night long
). I can also prove, perhaps to a lesser degree with my home security alarm log showing when I disarmed the alarm. However, taken together, and I think it's clear I was not at the location at that time. Could add iPhone GPS data if I must, but I don't think I have to go there. And, there is no damage to any of my vehicles.
I want to be ready with evidence in case they claim I was there and was involved.
So... I'm having a problem exporting a clip that shows me arriving home before the incident and still there (did not leave) past the time they claim I was involved in the accident. I have exported clips before. Right click, select Start Clip, move to end of desired clip (happens to be the end of the clip), right click, and select end clip. The start and end points are shown on the time line by a green and red indicator respectfully. I right click and select export clip. The selected clip length is approximately 1 hour and 1 minute. It takes a good 15 - 20 minutes if not more to export the clip. However, when I play back the exported clip, it is only the beginning of the clip and is only about 4 minutes in length.
Any idea what may be truncating the playback of the full selected clip?
I've done this 3 times and the clip only ends up being a little over 4 minutes long.



I want to be ready with evidence in case they claim I was there and was involved.
So... I'm having a problem exporting a clip that shows me arriving home before the incident and still there (did not leave) past the time they claim I was involved in the accident. I have exported clips before. Right click, select Start Clip, move to end of desired clip (happens to be the end of the clip), right click, and select end clip. The start and end points are shown on the time line by a green and red indicator respectfully. I right click and select export clip. The selected clip length is approximately 1 hour and 1 minute. It takes a good 15 - 20 minutes if not more to export the clip. However, when I play back the exported clip, it is only the beginning of the clip and is only about 4 minutes in length.
Any idea what may be truncating the playback of the full selected clip?
I've done this 3 times and the clip only ends up being a little over 4 minutes long.


