Positive Vibes thread...

sdkid said:
Click to expand...


Having seen that a few times before, there's something messed up with the recording. It always gets fuzzy as the video goes on..
 
  • Haha
Reactions: looney2ns
OK--- I have seen a lot of yardwork / landscape maintenance videos where they clean up a property. This was different-- and really cool. Watch the initial interaction with this couple, then skip around in the vid (or just watch it)...

 
  • Like
Reactions: SJGUSMC21, johnfitz and bigredfish
  • Like
Reactions: Broachoski, JNDATHP, mat200 and 2 others
sdkid said:
This is so damn cool-- but just what in the hell does that dog sense to know this is coming???

Click to expand...

They make the BEST humans!
 
  • Like
Reactions: sdkid
  • Like
  • Love
Reactions: TonyR and JNDATHP
  • Haha
  • Like
Reactions: gwminor48, sdkid, Old Timer and 2 others
sdkid said:
beautiful timing....

Click to expand...

That's in Clayton County, Georgia at the intersection of GA 138 and GA 85. I worked for that county for 2 years 1973 to 1975. It's where I began my 31+ year career in traffic signals. Me, Charlie and Ron installed 12 traffic signals in 13 months in that county. I was a trainee and dug holes and set poles, strung span, hung and wired up traffic signals, poured cabinet foundations, set cabinets and cut, wound and sealed inductive vehicle detector (wire) loops in the roadway. :cool:

A lot has changed there in 50 years! I'm not sure but it may be where I responded to where a leak from an underground natural gas line crept up the conduit and into a traffic signal cabinet where it was ignited by the arcing contacts of an older generation electro-mechanical traffic signal controller. The gas didn't burn due to very little oxygen but it did place enough soot and ash on some electrical contacts to where the controller (with it's vacuum tubes and analog circuits) could not time properly and basically got stuck in some interval. I recall the tiny explosion cracked the glass that allowed you to view the moving camshaft and the electrical contacts as the controller cycled. I think it was an Eagle ET175, ET115 or the like.

Dude got what he deserved, too bad his female co-conspirator got away untouched.
 
Last edited:
  • Like
  • Love
Reactions: mat200 and gwminor48
TonyR said:
That's in Clayton County, Georgia at the intersection of GA 138 and GA 85. I worked for that county for 2 years 1973 to 1975. It's where I began my 31+ year career in traffic signals. Me, Charlie and Ron installed 12 traffic signals in 13 months in that county. I was a trainee and dug holes and set poles, strung span, hung and wired up traffic signals, poured cabinet foundations, set cabinets and cut, wound and sealed inductive vehicle detector (wire) loops in the roadway. :cool:

A lot has changed there in 50 years! I'm not sure but it may be where I responded to where a leak from an underground natural gas line crept up the conduit and into a traffic signal cabinet where it was ignited by the arcing contacts of an older generation electro-mechanical traffic signal controller. The gas didn't burn due to very little oxygen but it did place enough soot and ash on some electrical contacts to where the controller (with it's vacuum tubes and analog circuits) could not time properly and basically got stuck in some interval. I recall the tiny explosion cracked the glass that allowed you to view the moving camshaft and the electrical contacts as the controller cycled. I think it was an Eagle ET175, ET115 or the like.

Dude got what he deserved, too bad his female co-conspirator got away untouched.
Click to expand...

Great job on that stop light @TonyR .. keep the traffic stopped until the LEO arrived

;)
 
  • Haha
Reactions: TonyR and johnfitz
You must log in or register to reply here.
Top Bottom