Review-Dahua/EmpireTech new doorbell cam Db6l 5mp
- Thread starter looney2ns
- Start date
I upped the bitrate to 8192 and turned OFF Backlight The video quality looks about the same as before - no change
Day time looks alright except that they video looks slightly out of focus until about 5 seconds and then everything snaps into focus. I set the PSS Camera setitngs back to 50 and set Backlight to WDR also 50 which if I recall were the original settings. I don't see and 'Default' button in PSS.
I have a perp whos stops by almost nightly to set fireworks off on my front porch which is why I bought the camera and hope to capture a pic of him for the police. He only shows up late at night. I bought this from your Amazon store and also bought two T2431T-AS 2.8mm today to replace some ailing cams
I have a perp whos stops by almost nightly to set fireworks off on my front porch which is why I bought the camera and hope to capture a pic of him for the police. He only shows up late at night. I bought this from your Amazon store and also bought two T2431T-AS 2.8mm today to replace some ailing cams
hmm, night time no WDR, Just select AUTO.
Also down the contrast to 50, no 100. Gamma add to 50.
Also down the contrast to 50, no 100. Gamma add to 50.
flynreelow
Known around here
- Dec 12, 2016
- 1,330
- 1,211
I'm not sure but during the daytime the video is out of focus for about 5 seconds and then everything is sharp. Perhaps at night due to the noise it is unable to do so. Just a guess.
The Receive buffer is set at 12mb At one time I had set it to 20mb but saw no difference so I set it back to 12mb
Changing to 10 made no difference. I looked at this with DMSS and see the same video quality issues and pulsations. I think I will return this to Andy's store on Amazon for a replacement. I will update this thread when I get a new camera installed - might take a few days though! Thanks for everyone's suggestions.
Have you done these steps ? Be sure sharpness is set to zero for night mode.
Review-Dahua/EmpireTech new doorbell cam Db6l 5mp | Page 3 | IP Cam Talk
I also suggest you do a factory reset. The reset button is on the back of the door bell (see instructions) Messing with too many settings using SmartPSS can confuse the doorbell and corrupt the image. My nighttime image looked just like yours on default settings, you MUST set the sharpness to "0" for night. Daytime image is great.
Yes, make a hard reset and check again too, press it for 5-7 seconds, make sure DB is powered and then can be defaulted and add again.
Here are the night settings and encode settings I used in the review.
I RESET the cam but now it connects to another hot spot that is not mine and I cannot access. It is grabbing 192.168.3.xxx while my domain is 192.168.1.xxx I can find no way to force it to mine. But the good news is that the Doorbell still rings, HA!
