cryptelli
Pulling my weight
International.International or english?
Sent from my SM-G928T using Tapatalk
International.International or english?
Sent from my SM-G928T using Tapatalk
I have an NVR4416-4K that suffers from the same issue. It drops frames on motion events between the opening and closing of the file. I do not have any reboot issues but also I do not use IVS at all. My NVR uses external alarm inputs and motion detection for the channels that do not have some kind of hard wired alarm setup.Does anyone know if this issue with the missing footage is limited to the 5xxx series or does the 4xxx series also have the issue? I've been looking at buying a 5208-4KS2 for my new home but am now considering the 4208-4KS2 if it doesn't suffer from this issue...
The question is Dahua aware of the issues, we not buying it from one of their authorized dealer and perhaps none of the customer that buy from authorized dealer aren't aware of this issue so it never get reportedWell that's a bit of a concern. I was set to put money down on one of these in the next day or two but if this is a preexisting issue on a previous model/generation then I can't see Dahua looking to fix it now.
Setup Tab-->System Menu-->General Tab-->HDD Full--> (Overwrite or Stop Record)My 12tb are all used up does it automatically overwrite oldest data, and is there a setting to enable/disable that?
They are very well aware of some of the issues, one of the reasons that Nellys dumped the Dahua line. I have worked with the dealers on this even remoting into my systems to check things. you are correct that most installers just set the systems up to record 24/7 and call it a day and the customers are not even aware of the features that they have. If you show them that Yellow motion line its over and they want it and when they see its dropping frames they want to know why. I do like the features but have switched to IVS because of that issue.The question is Dahua aware of the issues, we not buying it from one of their authorized dealer and perhaps none of the customer that buy from authorized dealer aren't aware of this issue so it never get reported
Major of authorized dealer customers aren't like us, know every detail of tech products we buy. Pretty much all of thier customer probably just buy and had it installed by dealer then never again see dealer unless the camera is non functioning
I have a 5216 with no built in POE and 2 x 4 TB WD drives, 10 cameras, a wifi router, POE switch, and cable modem all drawing ~70w.Hi guys
Can somebody tell me how much power would nvr5216-16p with 2 HDD and 3 PoE cameras use? I am trying to size a UPS to keep it going in case of power failure.
The difference is about 10w for all 10 cameras. Its not a lot.IR on or off? Think will change some with ten cameras.
I'm a newbie, so please be patient.All forms of RAID are absolutely worthless for IP Video Surveillance anyhow..
If you require redundancy and high availability; you can setup a hotspare NVR and cluster them, or just redundantly record to more than one recorder.. works so much better.
I've ordered a second NVR for a colleague and will test the cluster functionality as soon it arrives after my holidays. Probably mid of June. If it works fine I'll order a second NVR for me. At first I'll test the interoperability of different models in Cluster.I'm a newbie, so please be patient.
How can I redundantly record to two NVRs at the same time with the same group of cameras? How do I wire the system?
Do the motion detection zones I create, schedules, etc. work with the two NVRs and the same cameras without any issues?
Thanks in advance.