Tested how? From what I've read, cheap testers are just that, cheap and do nothing but continuity.Have you tested the cable you're using for this camera?
Because power and data use different pairs.Why would I have lights on cam if bad cable?
I mention here frequently that many people see wonky things until a factory reset, especially the new GUI and BI for some reason.Over the last few months I have had to do factory reset on several of my cameras (which i purchased from Andy). Not really sure, but only a small issue in my books. Most of my issues were surrounding shutter speed selection being applied and very slow connection to the cam gui's, the factory reset cleared them up, but to note I had to reconfig them manually because the config import had cause the same issues to happen a short time later.
No BI yet, just camera GUI -- I'm thinking a factory reset can't hurt -- tomorrow.I mention here frequently that many people see wonky things until a factory reset, especially the new GUI and BI for some reason.
As a matter of standard practice now, every new camera gets 3 factory resets before I set it up.
Maybe just luck or coincidence, but it does seem like a factory reset when one first gets the camera is a good way to start off without issues.
They are under the illuminator settings.Hello Everyone!
Last year, my friend bought two EmpireTech IPC-Color4K-T180 cameras from Endy and a few days ago we noticed that the LED lights on them did not light up.
Now I'm interested in whether it is included somewhere in the settings, and specifically that it does so by setting it so that when the camera detects some movement (human or vehicle) so that only then does the camera only turn on the LED lights?
Where to set it and how to turn on the LED lights on the camera on motion...?
Thank you!
View attachment 196260View attachment 196261
I use one of these quite regularly and it hasn't let me down yet for testing my ethernet cables.OK understood -- It did work for 7 or 8 hours today while I was at work. Is that typical of a wire issue, to go bad slowly?
I can always pull the cam down again tomorrow and set it up on my test tombstone. Maybe I should change the other connector too -- On the switch end. I have no real way of testing them other than plugging in another camera.
I'm running this:I try to find where in latest firmwares Dahua moved Image Stitching settings (to calibrate left/right image stitching point)?
Going over all menus for 20 minutes and I can't find it...
there is no Splicing menu in camera..I'm running this:
System Version:3.120.0000000.19.RBuild Date:2023-03-01
For me, SPLICING is located at CAMERA > SPLICING
What firmware are you on?
Did you do the 3 Reset button presses to default the camera after the update? Doing 3 factory defaults is not uncommon. But if that doesn't work, try rolling back to your previous version.there is no Splicing menu in camera..
Latest firmware from Andy website:
V3.140.0000000.22.R, Build Date: 2024-06-18
I did default to factory settings...Did you do the 3 Reset button presses to default the camera after the update? Doing 3 factory defaults is not uncommon. But if that doesn't work, try rolling back to your previous version.
google chrome...What browser you using?