Recent content by LocoRob

Going to hug the eaves of the house to better protect the cameras from the elements. Eaves are about 9ft to ground level approximately (9ft walls on house). My thought process now to future proof is to maybe install one of the nail on single gang low voltage boxes (orange hollow ones) and...

Hi All, in process of building an extension off the back of my house and doing a lot of pre-wire work before siding goes up. I only have a week or so left to get everything complete before my guys come in and get the addition weather tight. I'm running smurf tube so I can easily chase cat6a...

Looks like an interesting camera, but I can't find any online searching around, let alone even a round about price for it. Assuming you could connect a PIR sensor into the alarm input section of this camera? A PT camera you can pan and tilt remotely?

Interesting idea, didn't think of the little cubes. The specs say the IR is good for 10m. I think the distance from the front door to the corner of the ceiling I'd install is approximately 40' in distance. About how far do you say the IR is lighting up the room? And is the room completely dark...

Want to place a camera inside the house in the corner of a room with a 90* field of view (of the front window of the home and front entrance). The camera would be mounted to the ceiling. Really not sure what type/style camera may be best for the mounting position, but also performance. Night...

If you did this, wouldn't you need a POE switch to power the individual cameras?

Thanks guys, great suggestions! Any recommendations on a smallish tablet that could work where I could mount to the wall or on a stand?

Thanks for the heads up! No idea the Cat6a was so sensitive. Will need to be a bit more gentle when running through all the joists I drilled lol! Think I've been doing pretty good though. The 6-3 NM wire I ran through the joists for future hot tub is a different story!!!!

Now that I know where I can put some cameras on the back of my house, figure see if I'm on the right track for the front of the house. I attached two pictures showing the corner where I would position the camera, and the view the camera would have (via my android phone camera). The top left...

Thank you! Basically follows same principle then as point shoot cameras vs video cameras, makes sense especially if the sensors are the same size.

With all the research I've been doing, and the fact I tore up more dry wall last night by the front door to run a wire, I started thinking about if there was a way to integrate a small 7" or 9" monitor of some sort that would have a live stream from the front door camera. Rather than running to...

Lol! Nah, just a few precautions that required use of this cable, like future proofing, hdmi over ethernet, and the fact I can only run these lines about 6" away from power lines in certain areas (in middle of renovation), so want to reduce risk of interference. Was only a few dollars more to...

I think I just read that 2mp is a bit better at night than 3mp cameras? I tried to look for a 2mp 1 matrix camera, but come up with only turrets, no bullets. I think what I will do is a get a 2.8mm 2mp or 4mp 1 matrix bullet and mount it high by the spot lights (2nd floor) that shine down to...

Sound like if I can't find any NVR's without built in POE, then I should look for an NVR that meet the 802.3af and 802.2at standard. This would allow me to run a single cable from the NVR (located in office) to the POE Switch I'd located in the laundry room (in a cabinet). This method of...

Most NVR's I see discussed here have POE on each of the ports. What about NVR's that do not have POE and their capability? Are they any quieter than NVR's with POE built in? I'm curious if a non POE NVR may be best for what I'm trying to do, or would POE NVR's work as well as they are more...