Search results

I have searched through a number of posts on this but unable to find a solution to what I have happening. When using UI3 on a windows based machine I always have the "video stream lost" pop up. I run in a "live cycle" mode. Not a problem statically. It is very annoying and I don't have this...

I have browsed the forum and elsewhere and I know BI is only supposed to play back main when only one camera is displayed. Unfortunately I can't make it work. I can enlarge one camera to full screen or select a clip and either way only get substream unless there is a triggering event that pops...

I know that this forum recommends avoiding Reolink. That said I have some for the non critical locations. I have been trying to sync them to the local lan. The Dahua seem to be working and holding time but not the Reolink. They do not have access to internet and Reolink says that they must...

I have Open VPN up and working as best I can tell. Haven't been able to make it work with my cell phone yet though. With OpenVPN on in both my cellphone and BI server I put the server ip address followed by :81. No luck Also I am wondering if it has anything to do with the fact that I have...

Here I go again. Hopefully not as lame as last time. I am loosing all of the trigger times and indicators on the timeline. Just awhile ago I only had them back to 3PM today. Now they are all gone. Some new ones have appeared but the disappear within 5 minutes. Baffled. I now have 9000 GB...

I have my cameras installed and working on remote access. Have LPR working well. I now have an issue with retainage of any recordings for more than 8 hrs. I believe everything was setup correctly and have checked and rechecked. I need another set of eyes at this point. Attached are some...

I have all of my cameras setup, configured and working on there dedicated computer now with dual NIC. I have been exploring how to obtain remote access and viewing. This would be both within and outside the house. Ending up rather overwhelmed and have tried opertier, ngrok, etc but undable to...

Getting late and I am out of patience to figure out how to interface a dahua camera with blue iris. First I don't seem to be able to get Internet Explorer. When I try to open it defaults to MSN. Couldn't reach camera on default of 192.168.1.108 so used the configtool. Was able to...

I just acquired some cameras and a Dell Optiplex SFF 7050. I am not understanding how to connect audio in/out from cameras to allow two way communication via Blue Iris. Any help appreciated