Search results

PC power supplies don't have the 48-52 vdc POE voltage so a pc power supply would never work.

Yes I have. Fan does not turn on and 0VDC at both connectors both 12V & 52V are both showing 0. And yes, I am using a different power cord and right now the NVR is in my kitchen and for the past 18 months, it had been in my basement. So different 120V power source and different power cord. Still...

Well, it had worked VERY WELL over the past 24 months but last night was the coldest night of the year and I figure that all my outdoor POE dome PTZ cameras that have internal heaters probably had their heaters running full blast all night long causing the internal power supply in my NVR to...

You are both a gentleman and a scholar. With my limited experience, you are completely correct. When viewed from the NVR, all my IP cameras are 10.?.?.? when looking at their new IP DHCP address from the NVR!!

Chicken or egg?? Is the camera the chicken or the egg? In other words, I was successful when I reversed the order. but regardless, passwords and user name must match or the camera will not stream data to the NVR?? is that correct? When I buy a Lorex, Q-see, Amcrest or Dahua camera, is it...

When a IP camera is initially 'added' to a POE based NVR, such as my 16 channel LOREX, is the user name and password of the camera 'polled' by the NVR before the camera is added to the NVR? Reason I am asking is I have been having an issue adding a generic IP based ONVIF camera. I became...

It's also not possible to get into the settings through the Rj45/cell phone interface.

I have tried a VGA get get an error message from the monitor that this resolution isn't supported. I did open the unit and looked for a push button switch to reset to initial factory settings. No luck there either. I will take it home tonight and set it to 1080P and then bring it back. Thanks...

I moved (temporarily my Q-see QCK-81 NVR from a location that had a 4K monitor on HDMI. Everything worked fine when it was hooked up to a 4K monitor. When I moved to a new location, the monitor that I have now is a 1080P. Since I forgot to set the resolution back to 1080 before I moved it, I can...

The video output from my 16 channel LOREX NVR outputs a 4k HDMI signal that I feed into a 1 in 2 out 4K splitter. One output out of the splitter feeds a dedicated 50" monitor in my main living room. This 50" TV constantly is used 100% off to view the output of the NVR. The other HDMI 4K output...

I too have wondered if a SSD would be a good choice to upgrade a NVR. When I bought my 16 channel Lorex NVR, it came with a 3tb drive. Before I implemented the NVR, I replaced the drive with a 6tb drive of the same specification. It took me all of 10 minutes. At the time (4 months ago) a 6TB...

Can someone send me a link to purchase a pair of these ASUS routers? Amazon?? or EBAY?? --Greg--

Unfortunately, I'm more confused than ever. I have very fast cable modem (1GBPS) that outputs one port to my 24 port unmanaged switch at my home where my NVR is. Now do I need to get a new router? How exactly do I hook it up? Apparently I need to purchase two VPN capable routers? One for home...

Not sure I understand your question. I did not purchase a separate ip address for any of my cameras. And I haven't purchased the camera that I plan to use. Probably a Lorex 4mp ptz come type outdoor camera. If I decide to go the VPN route, I need specific help on how to do that. I unfortunately...

OK, at my home (where the HVR is), I have a gigabit download speed and 50Meg upload speed or often better. This is NOT fiber but cable modem. I expect to have the same at the remote site. It IS fiber based. Should be even better. Comcast internet at both locations. --Greg--

I own a 16 channel Lorex NR9163. So far I am VERY happy with it. I have 13 out of 16 channels filled up at and around my home all connected to the NVR with just Cat6 cables and the internal POE switch in the NVR. Now I want to install and monitor a camera 30 miles away. If I give that camera a...

For reference, my NVR is a Lorex NR9163. --Greg--

Yesterday there was a message on my 4K Lorex 16 channel NVR that new firmware was available. I installed it. yet, I see no documentation what actually was addressed. What exactly did this new firmware address? Does anybody know what this new firmware did? --Greg--

Yes, I am. that is one of a few that I use on a regular basis. There are many more. --Greg--

I spent over $5000 per year every year for 10 years. The light show was always free for anyone to view. On a good night we would have 500 cars with anywhere from 1-8 people per car. We did encourage people to bring a toy for toys for tots and we did collect food for our church's Christmas food...

Well, I want to put this discussion to rest and close it out. I am received the information that I need. Thanks everybody. --Greg--

I wont tell you my age but most likely I could be taken for any grandfather. I will tell you that I live in Colorado. I'm trying to do GOOD here. Not bad. Santa NEVER does bad. If you received a lump of coal in the past, my guess is that you probably deserved it. I have indeed handed out lumps...

Hopefully you wouldn't call the cops on Santa would you?? That would certainly make you a recipient of a lump of coal in your stocking.

For a while our home boasted the largest Christmas light show in our state. We had over 120,000 Led's on our home as well as 8 outdoor cameras. This year I am installing two IP camera very close to our street to gather license plate data from cars coming and going. The cameras I have selected is...

So is the main stream (to my NVR) and the substream to my phone running at the same time? When I am remotely looking at a camera through my android phone is the main stream suspended while I am using the 'substream' through my phone ?? Also, If am am looking at 16 cameras at a time through...

Main Stream: 4K(1~15fps)/3M(1~25/30fps) Sub Stream: D1(1~25/30fps) Third Stream: 1080P(1~25/30fps) These are specifications from a camera that I own. Please explain in detail if you understand 'substreams' Thanks --Greg--

Hi guys, I'm Greg from Denver Colorado. I had a 8 channel Q-See NVR and quickly outgrew it with indoor cameras. A month ago or so bought a 16 channel LOREX NVR 9163. Upgraded the 3TB with a 6TB. All went well. When I bought the NVR, I bought it without cameras. I have a mixture of 8MP, 4MP...