Dahua Mini Black Face PTZ (SD29204S-GN & SD29204T-GN)

Thanks again for the fast reply !!

oppsss i didn't see that one comming , it's a pitty coz i like that cam , bought 3 of them
any idea what gives me the same results but then for outside ?
 
install them some place they wont get wet, mine's outside but protected under a big eave... the weak point is the top of the unit, see attached photos and notice the SD card cover and reset button.. you could try a bit of silicon to seal everything up, as you can see none of it is gasketed.
 

Attachments

  • 057dce55-28b7-4292-ae65-2fc2d5b1ecf9_zpsaxodxkh5.jpg
    057dce55-28b7-4292-ae65-2fc2d5b1ecf9_zpsaxodxkh5.jpg
    307.9 KB · Views: 75
  • IMG_20160518_152435_zps0xmm6ktb.jpg
    IMG_20160518_152435_zps0xmm6ktb.jpg
    2.1 MB · Views: 77
I received my cam yesterday afternoon. Without any issue I was able to do the basic configuration changes in the cam.
After some struggling I was also able to get it online in my Hikvision DS-7608NI-I2 NVR using:
* Protocol: ONVIF
* Port: 80 as "Management Port"
* Disabled ONVIF auth

I'm not sure if this is the right "config". Is there any other way of doing or better one?

Dahua.Onvif.Online.jpg
 
Last edited by a moderator:
So far it's not working perfectly.
If I press the left or right direction button it will start moving in that direction but it won't stop If I "command" it.
 
still working perfectly, but its never been wet..
@kende, are you using the WebUI, SmartPSS, i/gDMSS or anything else?
 
Last edited by a moderator:
In this case I'm trying to control it through Hikvision NVR's WebUI.
The SmartPSS works fine. I'm not sure about the Onvif Device Manager. I will try out tonight.
 
that would likely be a Hikvision issue, not a Dahua issue.. Ive read reports here that Hik's Onvif capabilities are lackluster.. it sounds like its sending the correct start command but not the correct stop command.
 
Hello nayr,

I'm reading with post and i've seen a lot of videos with PTZ camera. Regarding all tests you've done, do you know some IP models running with POE and with intelligent detection (follow, etc ...) in a good price ?
 
your wanting auto tracking I take it? just forget it, its a flawed concept and simply cannot perform with a single input.
 
Hello nayr,

I will buy SD29204S-GN in next two months.
Do you maybe have PDF with CGI commands to control this PTZ camera ?

Thank you

Mladen
 
Installed mine for 2 weeks now. It has been working great. I also ordered the mounting hardware from the same vendor on Aliexpress. A few pictures attached here.
 

Attachments

  • 20160702_031454742_iOS.jpg
    20160702_031454742_iOS.jpg
    1.3 MB · Views: 148
  • 20160702_010523985_iOS.jpg
    20160702_010523985_iOS.jpg
    1,012.5 KB · Views: 120
  • 20160702_005647910_iOS.jpg
    20160702_005647910_iOS.jpg
    1.4 MB · Views: 112
  • 20160702_005205347_iOS.jpg
    20160702_005205347_iOS.jpg
    1.4 MB · Views: 108
  • 20160702_005049452_iOS.jpg
    20160702_005049452_iOS.jpg
    1.4 MB · Views: 106
  • 20160702_005035198_iOS.jpg
    20160702_005035198_iOS.jpg
    1.4 MB · Views: 102
sd29204S-GN.jpg Is this a new model, Waterproof/Weatherproof is listed in the "Items Specific" section? See attached.
 
I have my doubts coz when i starts to rain and the water comes between the moving part and it starts to freeze it will go broke ....just my opinion :)
 

Attachments

  • Screen Shot 2016-07-25 at 10.14.56 AM.png
    Screen Shot 2016-07-25 at 10.14.56 AM.png
    33.8 KB · Views: 53