Hi everyone,
This is my first post so apologies if not following the rules.
I decided to upgrade my Dahua DHI-NVR5432-16P-4KS2 to v4.0. I did it via ConfigTool and once the NVR rebooted it won't boot up.
It stuck on DAHUA 4 logo and after several seconds it reboots again. Think the upgrade didn't go very well.
This is the firmware I used: DH_NVR5XXX-4KS2_MultiLang_NP_V4.000.0000000.1.R.20190809.bin
And this is the firmware I had before: 3.215.0000001.0
I tried using the RS232 connection but it wasn't showing anything on the console.
Anything else I could try before sending to the repair?
This is my first post so apologies if not following the rules.
I decided to upgrade my Dahua DHI-NVR5432-16P-4KS2 to v4.0. I did it via ConfigTool and once the NVR rebooted it won't boot up.
It stuck on DAHUA 4 logo and after several seconds it reboots again. Think the upgrade didn't go very well.
This is the firmware I used: DH_NVR5XXX-4KS2_MultiLang_NP_V4.000.0000000.1.R.20190809.bin
And this is the firmware I had before: 3.215.0000001.0
I tried using the RS232 connection but it wasn't showing anything on the console.
Anything else I could try before sending to the repair?