Recent content by epcjay

I googled and came to this thread. For anyone who cares about ONVIF on Dahua, what you need to do first is setup on the webgui to have no authentication first. Login using ONVIF Device Manager and you should not need a password with access to admin controls. Go to "user management" and it...

I am having a hard time adding this unit to my NVR after a factory reboot. The image does not show, however the NVR acknowledges that the doorbell is there cause the status is green Any ideas anyone?

OP, I am getting conflicting info and would like your assistance. In the specs, they it says POE 802.3af for power, but some descriptions note I have to purchase a specific DAHUA one. What did you use?

I just wanted to add here that I've been ordering from this store a few times -- VIKYLIN TECHOLOGY Store - Small Orders Online Store, Hot Selling and more on Aliexpress.com | Alibaba Group and they are Xinray themselves but with a different name. They are slightly cheaper than the original...

I use Poe switches for power purposes. In the event a thief makes it out with my NVR, I know that my cameras still have POE power via a seperate switch and so the cameras are still recording to the memory card inside the camera

One of my clients are looking for a doorbell, but I am trying to find one with the least amount of hiccups which connect to a screen when pressed. I'm not sure if I'm sold out the Hik door bell yet. I like the dahua villa series..that looks like what I want but with a Hik setup, I wonder how...

Look under Record > Parameters. This will tell you what the camera is recording at.

You may want to email Hikvision support for assistance in resetting the camera password if you bought it from an authorized dealer as they were very helpful for me before touching the firmware route above. One of my clients had their system hacked and passwords reset so I emailed hikvision and...

I wanted to add the code generator didnt work for my NVR using SADP, however I was able to use the code on the NVR itself using the hidden button on the bottom left.

Ribbon cable? :p

What's your internet connections like? I have no issues playing back on 30down/5up internet connection while my cell phone is LTE.

Xinray for cameras, not sure about a managed POE switch. A lot of off lease cisco 3750 managed switches that offer POE and in my area off Kijiji for about 90cad Good luck.

5 minutes of trying to access the camera, no go. Now I'm not sure if it's cause it's dead to begin with or I flashed it without the ribbon cable attached....

Telnet seems to be dead... C:\Users\epcjay>telnet 192.0.0.64 Connecting To 192.0.0.64...Could not open connection to the host, on port 23: Connect failed I'm also noticing a break in the pings every 30-40 seconds. Perhaps its on a bootloop. I don't think I'll invest anymore time on this...

You can set it to record @ 1080p and 720p as you wish. It's all up to you. I want to say Dahua camera should work with this NVR, but I cannot guarantee this model: DaHua IPC-HDW4431C-A POE Network Full HD 1080P 4MP IR Mini Dome IP CCTV Camera | eBay I use another Dahua camera which has PTZ...