Search results for query: Hikvision pigtail

  1. S

    Wiring diagram for water damaged rj 45

    I am not using pass through. Using this Cat5e UTP Connector - Cat5e UTP RJ45 Connector in Components | D-Link India. Are they good for stranded wires ? I have extensively used them in solid cat6 without any problem.
  2. TonyR

    Wiring diagram for water damaged rj 45

    Pass-thru, 3 prong contacts for solid or stranded, RJ-45 male crimp connectors on amazon here. Use your image in your post #13 but with grey and purple swapped as you did before that worked. Once working and tested, I suggest this time you protect your connection from the weather, neighbors and...
  3. S

    Wiring diagram for water damaged rj 45

    pin number doesn't matter if you are going by corresponding color code
  4. TonyR

    Wiring diagram for water damaged rj 45

    I don't have a Hikvision camera and I have not replaced a RJ-45 connector on one. Also, I'm not pointing out the following because I think it will resolve your issue about having to restart the POE switch but the pin numbers of the image you posted are wrong IF that is a female RJ-45 and the...
  5. C

    DH-PFA151 (Corner Mount Bracket) + DH-PFB305W (Wall Mount Bracket) + DH-PFA120 vs DH-PFA126

    In Australia, Home Depot is known as Bunnings Warehouse. They used to stock the CRC dielectric grease, but no more. So, I have turned to Amazon and eBay. I found this one: https://www.amazon.com.au/Waterproof-Insulation-Dielectric-Electrical-Connectors/dp/B0D8NT2RWB/ Before I place an order...
  6. TonyR

    DH-PFA151 (Corner Mount Bracket) + DH-PFB305W (Wall Mount Bracket) + DH-PFA120 vs DH-PFA126

    The specs for the PFA-120 you linked state that the hole diameter at the back is 50mm. I'd consider a closed rubber grommet for the hole, sealed in-place with non-gassing silicone sealant. You can also apply the sealant to the CAT cable after drilling a small hole in the solid part of the...
  7. yorkie

    Wisenet / Samsung IP cameras and 2-way audio

    I have a Samsung PNF-9010RV and a Wisenet XNF-8010R fisheye camera (one is 12mp, the other 6mp) and am having issues with the audio interface. Getting sound FROM the cameras is fine, though the Samsung one is a fair bit quieter than the newer Wisenet one.... My problem is getting any audio TO...
  8. TonyR

    Camera Water Issue

    Even if not in direct weather, thermal cycling (warming up, cooling down) also causes devices to drawn in damp air that condenses and collects but never exits so its important to also caulk the pigtail that enters the camera with non-gassing sealant, waterproof the Ethernet connection and use...
  9. TonyR

    ENS Cam Dead

    I assume you've tried a different POE port; is the cam's IR-cut filter clicking when powered up? Have you tried cleaning the male-to-female RJ-45 connection with De-OXit D5? If so and it tests OK after that, be sure to use dielectric grease and water-proof as here. Since your'e lucky enough to...
  10. bp2008

    New member looking to replace UniFi Protect with fully local setup

    I think Ubiquiti is quite rare in how they often put RJ45 connectors directly on the camera, not using a pigtail. It is actually a really nice feature now that you mention it. I can't think of any outdoor models from Dahua or Hikvision which don't use a pigtail. In fact the last outdoor...
  11. P

    RTSP stream with sound but without video... sometimes

    Thanks for very detailed answer! I suspected that the problem may be in the cable so I re terminated the end of the cable going into the switch did not seam to have much effect. It is strange though I did use the included connection protector that comes with: something similar to this...
  12. TonyR

    RTSP stream with sound but without video... sometimes

    My first choice would be a problem with the cable and/or its connectors. Moisture and the resulting corrosion at the connection of the male RJ-45 to the female RJ-45 on the camera's pigtail is especially subject to corrosion. When weather permits, open up that connection and inspect it. Clean...
  13. V

    replacement Hikvision pigtail

    Just dropping by to show my gratitude and post a more recent update on this. I had no end of problems "decoding" the wiring on my DS-2CD2383G0 which stopped functioning after relocation. I assume during the removal and installation the pigtail became damaged. One thing all the various threads...
  14. CanCuba

    How to ideally seal a cable hole in a 5" PVC camera mounting box?

    On a FB group for electric issues, I recently saw a thread where many electricians suggest making a drain hole in the box if one isn't present. If the box is tightly sealed, external water won't get in but some expressed a concern about condensation building up over time inside the box. Others...
  15. TonyR

    How to ideally seal a cable hole in a 5" PVC camera mounting box?

    If the OP is using a diecast metal box as pictured I highly recommend sealing the box completely, not allowing it to have loose fittings and covers to allow atmosphere in to supposedly allow water to overcome the surface tension (viscosity) that water has that would prevent it from draining out...
  16. G

    Dahua Imou 12v PoE options

    Those are great points, thank you very much! I was leaning towards the POE to 12v pigtail splitters as they seem to be the easiest route to go, I had thought about putting heat shrinks and silicone over the connectors but the dielectric grease is a great idea and so is the self fusing tapes...
  17. TonyR

    IPC-B5442E-Z4E Replacement

    I understand your frustration and that you seek to change camera brands but any camera, including Hikvision, can have moisture issues, as shown by the many instances here ==>> site:ipcamtalk.com hikvision moisture . If you decide to switch anyway, please consider the following in case your new...
  18. TonyR

    Dahua Imou 12v PoE options

    I would go ahead with the POE-to-12VDC-splitter you linked and then use dielectric gel on the RJ-45's and the 12VDC barrel connector then weatherproof all 3 connection junctions with self-vulcanizing rubber tape and quality vinyl electrical tape as outlines in an excerpt below from the original...
  19. alastairstevenson

    HikVision turret camera connect without pigtail

    edit I just realised you're looking for turret cameras, as opposed to the bullet format that I've referenced below. There are quite a few Pro-Series cameras such as the DS-2CD26xx series that have built-in ethernet sockets as opposed to being on pigtails - you'd have to browse the products...
  20. mironto

    HikVision turret camera connect without pigtail

    Of course I would seal the hole for ethernet cable. So can anybody confirm there are no current HikVision turret cameras that do not use pigtail?
  21. TonyR

    HikVision turret camera connect without pigtail

    Go with option 1. At the very least apply dielectric grease to the connection but ideally, perform the complete weatherproofing method.
  22. mironto

    HikVision turret camera connect without pigtail

    I am looking for a HikVision turret camera that can connect PoE ethernet cable with RJ45 plug straight into the body. From what I've researched the current cameras DS-2CDx3xx seem to use some pigtail that needs to be connected to ethernet cable outside of the cam body and water sealed. I need to...
  23. TonyR

    Camera cable termination

    +1 to all the above ^^^. Ideally, use the junction boxed designed for the specific camera to additionally protect the camera's pigtail. Some more, detailed info below: https://ipcamtalk.com/threads/hikvision-ds-1280zj-dm21-correct-way-for-a-watertight-installation.47647/#post-444148
  24. M

    Lorex cable connection standard

    No, I have installed an RJ25 socket unit in the back of a cupboard. The faceplate allows four sockets to be installed. Unless, of course, that is what you meant. Unfortunately the boat has sailed in terms of the cable used and already installed. With UK building construction, there are not...
  25. TonyR

    Lorex cable connection standard

    Did you cut the connector off because of the 3/4" to 1" hole required for the camera's pigtail? If so, maybe next go-around consider this: they make junction boxes for specific make/model of cameras that houses and protects the pigtail from direct exposure to moisture and sunlight. The box also...
  26. TonyR

    Solutions to Mount PoE Cam to 1 Gang Box

    I'd mount this gangbox adapter on the single gang box (purchase here.) Then mount the junction box that is made for the camera onto the adapter. The JB (junction box) will house the bulky camera pigtail and protect it. Since the cams are under a roof eave the cables will be fairly well protected...
  27. TonyR

    install 101 question

    Use solid (not stranded) copper (not CCA/Copper Clad Aluminum) cable with the right jacket for the application. Use "CMR" (R=Riser) rated jacket for in-walls, between floors, and in crawl spaces and attics. It can be used under eaves and soffits if not directly exposed to sun and rain. For...
  28. TonyR

    Looking for IP camera and NVR system to monitor beverage packaging

    And you'll need a good POE switch ==>> NETGEAR 8-Port Gigabit Ethernet Unmanaged PoE Switch (GS108LP) - with 8 x PoE+ @ 60W Upgradeable, Desktop, Wall Mount or Rackmount, and Limited Lifetime Protection NOTE: The above switch is not industrial-rated and should be located in the same environment...
  29. TonyR

    Anyone ever install on a doublewide?

    I put 4 cams on a single wide in 2017. Took the four CAT-5e's down through 2 holes in floor next to the wall and behind an entertainment center where the NVR would live on bottom shelf; be sure stand out from the wall enough to avoid steel truss, it was about 4" there, IIRC. Removed 1 section...
  30. TonyR

    Burnt PoE Pins on Camera & Cable?

    Looks like corrosion due to water ingress. Below is a quick copy & paste from a Nov. of '22 thread that I replied to, it has some good links. If you haven't already done so, this below is my suggestion to try and clean the female RJ-45 on the cam's pigtail: I would recommend replacing the...
Top