cams

  1. B

    Needing Budget Friendly and Effective Outdoor Setup

    Hello All, I'm a newbie here and looking for some advice for a new outdoor cam setup that is budget friendly. Before we get into details, yes I've read the newbie post that outlines the ideal things you want in a system. With that being said, I need some opinions on outdoor cams. We're...
  2. Chust

    Change frame rate at a specific time in bi?

    I use d2d for recording. During the day I set my cams to 15fps in the camera software. I set bi recording fps to 20 due to blur/streaking/pausing if set to 15fps... Now at night the cams switch to 7.5fps in the cameras software. I set bi recording fps to 10 due to blur/streaking/pausing...
  3. N

    Ip Cameras and network traffic

    I'm planning on setting up an IPCAM system currently it will be small 6 cams, I will eventually expand to 26. My current network at my office is a 192.168.1.* network, would I also use this this same subnet for my cameras? or is it best practice to setup another subnet? If I put all cams on...
    • nambi
    • Thread
    • 192.168.1. cameras cams network subnet
    • Replies: 11
    • Forum: IP Cameras
  4. TechBill

    Store

    You have a walk in store correct? If I recalled in Tulsa, OK? I am from Springfield MO so it like less 3 hours drive from me unless your on the west side of Tulsa. Do you have some cams and NVR on display for demo that I could look out and try out before purchasing? Thank you Bill
  5. O

    Hello to all from Germany

    Hi Guys, I´m Oliver from Germany and my profession is SAP consultancy. I discovered the world of wireless IP Cams when I had to find out which of my 2 cats is peeing on the sofa. Since then I had about 15 different models in my hands, mostly clones of the Tenvis JPT3815 and their successors in...
  6. J

    Monoprice new IP cams - looks like hikvision

    looks like monoprice now carries hikvision.. http://www.monoprice.com/Product?c_id=110&cp_id=11006&cs_id=1100618&p_id=12463&seq=1&format=2 doesnt say it, but sure looks like it - a little pricey though... good thing we have milkisbad :)
    • jimmyt
    • Thread
    • cams hikvision milkisbad monoprice pricey
    • Replies: 1
    • Forum: Hikvision
  7. C

    No new clips in viewer

    My clip viewer is on the right panel as always but it isn't scrolling or showing any new clips. The cams are recording to the appropriate folder but no clips?
  8. N

    nvr or computer 5 cams.

    I plan to install about 26 Hikvision 3 MP cams around my office and factory, but we may be going through some renos here so in the mean time I want to install about 5, since I will eventually use these same 5 when I add the extra 21 cams I'm hoping I can have a temporary nvr / computer solution...
  9. W

    Can't Find New Hik 2032's

    Sorry if this has already been covered. I've seen discussion of similar issues, but with other problems being discussed, I'm a little confused as to what to do. Just received 2 more Hik 2032's from China (stickers say firmware 5.2.8 and dated 1/2015)..I power them up (IR lights turn on) but I...
    • wxman
    • Thread
    • camera cams computer connected directly
    • Replies: 8
    • Forum: Hikvision
Top Bottom