Recent content by Deali

Great, can you reach the NVR from the PC, i mean can you log in from the IE Browser to the NVR? It is strange that you can see a camera from the NVR because the Camera has still an adress of 192.168.1.108 What have you done so far?

You can do change the NVR to the 10. network. After you log in to your NVR with the Monitor attached there is a tab called "Setting" Click that and then on the left side click "Network" and then "Tcp/ip" Put in 10.0.1.100 under IP Address and 10.0.1.1 for Default Gateway Then save it. But as i...

And if you try to rearrange the IP-adresses please disconnect everything from the switch. Only your Computer should be connected to the switch. Then connect the first camera into the switch and modify the IP, then the next and so on. Let us know the IP of your PC. It would be easiest if it...

You have everything enabled, so the chance of an error which occur somewhere is very big. Continuous is working, we can see, just switch off everything and then enable only Motion. If that is working then test Continuous and Motion, then switch off everything and test only IVS.

in the Period screen you only checked Sun. Hope that you clicked on All before you saved it.

I thought audio is not worth it. It was switched on with my new cam´s. It is really great, very sensitive!

I ordered one today, without PoE, Aliexpress has some kind of celebration, got mine for 195€ which is 210$ Great day!

Might be, these where really cheap cables. I took them out, i can´t see any defective areas. I replaced all cables now with cat 6 and all cam´s work as expected (i had problems with 2 cam´s on the 20 meter cables before).

Today i found out the the Dahua cams are more sensitive to cable quality and length than others. I had a Sony Cam on a 20 meter cat 5e cable and i replaced the cam with a Starlight. It did not work at all. I used external powersupply, i tried PoE, no camera was found. I tried another Starlight...

Thank you, i got it. i never went down to the end. But indeed, 1-32 is for Main-Channel and then A1-A32 is for Sub-Channel.

On my NVR 4832 i am recording the substream of channel 12. on the WEB-interface i have no button to select between main and sub on SmartPSS i have the choice to select it Can someone tell me if it is a bug or unique to my system?

I postet this in the dahua-starlight-varifocal-turret-ipc-hdw5231r-z thread I got my ipc-hdw5231rp-z cam today. I seem´s that it is a DOA. I put it on the network and tp a 12V PS. I cant reach it with the Config Tool. It does not make any noise. All my other cam´s operate the ir-filter if i...

I got my ipc-hdw5231rp-z cam today. I seem´s that it is a DOA. I put it on the network and tp a 12V PS. I cant reach it with the Config Tool. It does not make any noise. All my other cam´s operate the ir-filter if i apply power. On my router i can not see that something is connected to the port...

I could not resist, i found this on ebay. It came with a 500GB harddrive in it, a CD and a nice, printed manual. This is a complete remote system. You put it in a network and the rest is done from a computer. It has one Gigabit Ethernet port. It can handle 12 chanel and two disk drives...

Back to the topic: in a case like this i would move the suspected camera to the place of a good working one and the good working one to the cable were the new one did not work. Do a factory reset to the suspected one. If the problem still exist it is the camera. With the known good one you have...