I am using 180809. Since I installed this firmware, my camera has stopped disconnecting from my network. Works really good.
Downloads, Firmware & More - IP Video Security Solutions | LTS
Download the latest firmware updates as well as other software applications. LTS puts intelligent solutions in your hands. Check us out today!
www.ltsecurityinc.com
Search for LTK6128W-WIFI
Where can I find this magic V1.4.62 build 171201 firmware with the possibility to set 22 fps?
alastairstevenson
Staff member
Is that what's referenced in the link in the post 2 above?
DOWNLOAD EU PORTAL
I have also have 180515. Is there a newer version? Someone posted above 180809, but I can't find that anywhere.
It's the zip file in the root directory above.
ftp:/ftp.hikvisioneurope.com/Technical%20Materials/07%20%20Video%20Intercom/00%20%20Product%20Firmware/IP%20Door%20Bells/Wi-Fi%20Door%20Bell/DZ20180521_111_28_H2_EN_STD_V1.4.62_180809.zip
ftp:/ftp.hikvisioneurope.com/Technical%20Materials/07%20%20Video%20Intercom/00%20%20Product%20Firmware/IP%20Door%20Bells/Wi-Fi%20Door%20Bell/DZ20180521_111_28_H2_EN_STD_V1.4.62_180809.zip
^Thank you @asustitan . I managed to download the file. What is the easiest way to update the firmware on the camera? Will I loose all the settings and have to setup the device again?
@asustitan Found this same file on another website, but there is a note that this firmware is only for KB6403. Does this mean that the 180809 version might not compatible with KB6003?
sparker
n3wb
Hi, I disconnected JP14 and JP15 yesterday, and while night vision is now greatly improved, it appears that motion detection recording in night view no longer works. I continuously record via NAS (because alarm recordings aren't supported in Surveillance Station) and was able to confirm there was an event at 4:55am in front of my door (happens around the same time every morning, because it is a paper delivery) but it was not detected or recorded via the app and onboard storage card. Events that took place when night vision switched to daytime, do detect motion detection events.
I have mine set to the lowest because the camera is quite close to the road and I don't want to record every car or bicycle that passes in front of it.
wayguk
n3wb
- Jan 29, 2018
- 14
- 0
How did you take the device apart? I have moisture on the inside of the lens and want to clean it and reseal it.
Took mine apart this weekend, Yep I would think there is room for some near the bottom, Disabled the IR sensors too
just to let you know, i just flashed the v1.4,62 build 180809 firmware onto my KB6003 and it works perfectly fine (so far). I am hoping it resolves the intermittent disconnect from hik-connect (which until now has required a reboot vai the ip address config page).
Here's a firmware that'll allow you to change the frame rate. Its from LTS and allows changing from 1/16 to Full Frame Rate. Created an account just so I share it. Happy Thanksgiving and stay safe.
